Micro Control MCS-BMS-GATEWAY Guide de dépannage télécharger pdf (Page 133)

MAGNUM VERSION 8 MANUAL REVISION 3.1

133

If you are going to manually assign the IP Address, Subnet Mask, and Default Gateway.



Press the Menu key, select Serv Tools, and then press the Enter key.



Select Ethernet Network then press Enter.



Set “DHCP Enabled” to NO.



Set the “IP Address”.



Set the “Subnet Mask”.



Set “Default Gateway”.

If you are going to let your network assign the IP Address, Subnet Mask, and Default Gateway:



Press the Menu key, select Serv Tools, and then press the Enter key.



Select Ethernet Network then press Enter.



Set “DHCP Enabled” to YES.



Connect the MCS-Magnum to the network and power up the board.

Johnson N2

11.11.4.

The N2 address can be verified and changed (with the proper authorization code) from the keypad/LCD.



Press the Menu key, select Serv Tools, and then press the Enter key.



Select RS485 Network then press Enter.



Select Protocol then press Enter. Change the protocol to N2.



Select address then press Enter. Change the address then press Enter.



Select Baud then press Enter. Set the baud rate then press Enter.



Connect the communication wires to the TX RS485 three-position terminal located above the Ethernet

connector.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 161 162

Pas de commentaire

Micro Control MCS-BMS-GATEWAY Guide de dépannage Page 133