Micro Control MCS-BMS-GATEWAY Manuel d'utilisateur télécharger pdf (Page 20)

GETTING STARTED MANUAL REVISION 2.0

 Press the Menu key, select Serv Tools, and then press the Enter key.

 Select Ethernet Network then press Enter.

 Set “DHCP Enabled” to YES.

 Connect the MCS-Magnum to the network and power up the board.

Johnson N2

The N2 address can be verified and changed (with the proper authorization code) from the keypad/LCD.

 Press the Menu key, select Serv Tools, and then press the Enter key.

 Select RS485 Network then press Enter.

 Select Protocol then press Enter. Change the protocol to N2.

 Select address then press Enter. Change the address then press Enter.

 Select Baud then press Enter. Set the baud rate then press Enter.

 Connect the communication wires to the TX RS485 three-position terminal located above the Ethernet

connector.

The MCS Sensors Quick Reference Sheet

1 2 ... 15 16 17 18 19 20 21 22 23 24 25

Pas de commentaire

Micro Control MCS-BMS-GATEWAY Manuel d'utilisateur Page 20